Skip to content

How to use a teleprompter: setup, speed and eye-line

Put the text as close to the lens as you can, just below it, set the scroll to your talking pace rather than your reading pace, and rehearse out loud before you record. Here is how, for phone and tablet apps and for glass rigs.

By our team. Published . 5 sources.

Try it in Cuefold, free

To use a teleprompter well, put the text as close to the camera lens as you can, ideally just below it, keep only a few short lines on screen, and set the scroll to the pace you talk at, not the pace you read at. Read the script out loud twice before you record, then look at the words through the lens rather than at them. Everything below is the detail behind those four steps, for both phone and tablet apps and glass rigs.

The two kinds of teleprompter

A screen next to the lens. A teleprompter app on a phone or tablet shows the script on the same device that is filming, usually just under the front camera. Nothing else to buy. Your eyes are slightly off the lens, so placement matters (see "Get the eye-line right").

Glass in front of the lens. A rig puts a sheet of partly mirrored glass at 45 degrees in front of the camera, with a screen lying underneath it face up. You read the reflection of the screen; the camera looks straight through the glass and does not see the text [1]. Because the reflection sits on the lens axis, reading looks like eye contact even from close up. The screen under the glass can be a dedicated monitor, a tablet or a phone running a prompter app.

The rest of this guide works for both. Where they differ, it says so.

Set it up

  1. Put the camera at eye level. Raise the phone, tablet or camera until the lens is level with your eyes when you sit or stand as you will film. Looking down into a lens from above is unflattering and makes reading more obvious.
  2. Phone or tablet: use the camera on the screen side. That is the front camera on most devices, so the text and the lens are on the same face. Put the text right under the lens, not in the middle of the screen.
  3. Glass rig: mirror the text. The glass reflects the screen, so text shown normally reads backwards in the glass [1]. Turn on your prompter app's mirror setting, which flips the text left to right so the reflection reads correctly. Set the glass at 45 degrees and fit the hood so stray light does not wash out the reflection.
  4. Stand back further than feels natural. The further you are from the lens, the smaller the angle your eyes move through as they follow the text. There is a table of real numbers below.
  5. Make the text big and narrow. You should be able to read it comfortably from where you are, without leaning in. Narrow columns mean less side-to-side eye movement, which is the giveaway viewers notice.
  6. Turn on Do Not Disturb so a notification does not cover the script or ruin a take.
  7. Lock focus and exposure. In the iPhone Camera app, touch and hold your face on screen until you see AE/AF Lock, so the picture does not pulse as you move [2]. Many prompter apps have their own focus lock or handle this for you.

Get the eye-line right

Viewers are much more forgiving of a gaze that drops slightly below their eyes than one that drifts to the side or above. A study of eye contact over video found people were about ten times less sensitive to someone looking below their eyes than to someone looking left, right or above [3]. That is why the most forgiving place for prompter text on a phone or tablet is directly under the lens, and why you should never put the script in a window beside the camera.

How far your eyes move depends on how far the text is from the lens and how far you are from the device. Here are the angles, worked out with basic trigonometry:

Your distance from the deviceText 1 cm below the lensText 2 cm belowText 5 cm below
40 cm (phone in hand)1.4°2.9°7.1°
60 cm (phone on a desk stand)1.0°1.9°4.8°
100 cm (tripod across a desk)0.6°1.1°2.9°

The lesson is in the corners: text 5 cm down at arm's length moves your eyes five times as far as text 1 cm down from a metre away. Keep the reading line in the top centimetre or two under the lens and step back.

On a glass rig, the text is already on the lens axis, so the remaining giveaway is your eyes tracking across long lines. Keep the column narrow and the font large.

Prepare the script for the prompter

A script that reads well on paper can be awkward on a prompter. Before you load it:

  • Use sentence case. All capitals are slower to read and hide where sentences start.
  • One idea per line or short paragraph. Break long sentences into two. A full stop is a free breath.
  • Write numbers the way you say them. "Twenty twenty-six", "about fifty per cent", "two point five million". You will stumble less, and the prompter's timing will be closer to your real pace.
  • Spell hard names the way they sound the first time, in brackets after the real spelling, and remove the brackets once you have them.
  • Mark pauses with a line break, not a symbol. An empty line is the easiest cue to see out of the corner of your eye.
  • Remove anything you will not say: headings, notes to self, links, stage directions you do not need.

Set the speed

Start from real numbers rather than a guess. Audiobook narrators average about 155 words a minute [4], and radio news is usually written for 160 to 180 [5]. Those are sensible starting points for a script read to camera. If your prompter sets speed in words per minute, start at about 140 to 150 and adjust. If it uses its own units, set a speed that finishes a 150-word passage in about a minute, then fine-tune.

There are two ways the text can move:

  • By the clock: the text scrolls at a steady rate. Simple and predictable, but you have to keep up, and a pause or an ad-lib puts you behind. Learn where the pause control is (often a tap on the screen) before you record.
  • By your voice: the app listens and moves the text as you speak, stopping when you stop. This makes pauses free and removes the "chasing the text" feeling, at the cost of needing a reasonably quiet room.

If someone else is running the prompter for you, they should follow your voice, not lead it.

Practise before the camera rolls

  1. Read it aloud once, slowly, to catch words that trip you up. Rewrite them now; it is your script.
  2. Read it aloud again at full pace with the prompter running, standing or sitting as you will film. Adjust the speed and font size.
  3. Record one warm-up take you expect to throw away. It takes the pressure off and gives your face and voice time to loosen up.

Let your eyes run a line or so ahead of your mouth. You will see full stops and line breaks coming, and your phrasing will sound like speech instead of word-by-word reading.

Common mistakes and how to fix them

MistakeWhat viewers see or hearFix
Text in the middle of the screenEyes clearly below the lensMove the reading line to just under the lens
Sitting too closeEyes visibly scanningStep back and make the font bigger
Long linesEyes moving side to sideNarrow the text column
Scroll too fastRushed, breathless deliverySlow down or switch to voice-following
Scroll too slowLong gaps, then a rushSpeed up or use voice-following
Reading every word at the same weightFlat, robotic toneMark one key word per sentence and lean on it
Stopping at every flubMany short takes, no flowPause, go back to the start of the sentence, carry on
Glass rig text backwardsPresenter cannot read itTurn on the app's mirror setting
Screen too bright in a dim roomGlow on the face, squintingLower screen brightness

When you flub a line

Do not stop the take. Pause for a second, go back to the start of the sentence, and say it again. A clean restart at a sentence boundary is easy to cut in any editor, and keeping the camera rolling keeps your energy up. Some teleprompter apps now do the cutting for you: Cuefold, our app for iPhone and iPad, follows your read against the script, keeps your last good read of every line and cuts the flubs.

Quick checklist

  • Lens at eye level, text right under the lens (or glass set at 45° with the text mirrored)
  • You at least an arm's length away, font large enough to read from there
  • Script in sentence case, short lines, numbers written as words
  • Speed set from a timed read, or voice-following on
  • Do Not Disturb on, focus and exposure locked
  • Two read-throughs out loud, one warm-up take

Common questions

How far should you sit from a teleprompter?
As far as you can while still reading comfortably. With a phone or tablet, an arm's length or more keeps your eye movements small: text 2 cm below the lens moves your eyes about 2.9° from 40 cm away but only about 1.1° from a metre away. Make the font bigger rather than moving closer.
Where should the text go on a phone teleprompter?
Directly under the front camera lens, in a narrow column. Viewers are about ten times less sensitive to a gaze that drops slightly below their eyes than to one that drifts sideways or up [3], so just below the lens is the most forgiving place.
What speed should I set my teleprompter to?
Your talking pace, which for most people reading to camera is roughly 140 to 170 words a minute. Audiobook narrators average about 155 [4] and radio news is written for 160 to 180 [5]. Time yourself reading 150 words aloud and set the prompter to match, or use a mode that follows your voice.
How do you not look like you are reading from a teleprompter?
Keep the text right next to the lens, step back, use short lines in a large font so your eyes barely move, and rehearse until you know the shape of each sentence. Let your eyes run a line ahead so your phrasing sounds like speech.
Why is the text backwards on my teleprompter?
Glass teleprompters show you a reflection of the screen, which reverses the text [1]. Turn on the mirror setting in your prompter app so the reflection reads the right way round. On a phone or tablet without glass, leave mirroring off.
What should I do if I lose my place?
Pause, find the start of the sentence, and say it again from there. It is easy to cut later. To lose your place less often, slow the scroll, enlarge the text and keep the reading line in the same spot near the lens.

Sources

Checked on 5 November 2026.

  1. 1.Glide Gear, "The science behind teleprompter beam splitter glass" (45° angle, reversed text): https://glidegear.net/blogs/news/the-science-behind-teleprompter-beam-splitter-glass
  2. 2.Apple, iPhone User Guide, "Use iPhone camera tools to set up your shot" (AE/AF Lock): https://support.apple.com/guide/iphone/use-camera-tools-iph3dc593597/ios
  3. 3.Chen, M. (2002), "Leveraging the asymmetric sensitivity of eye contact for videoconferencing", CHI 2002, Stanford University: https://graphics.stanford.edu/papers/eye_contact/
  4. 4.ACX Help Center, "How long will my narrated audiobook be?" (about 9,300 words an hour): https://help.acx.com/s/article/how-long-will-my-narrated-audiobook-be
  5. 5.Rodero, E. (2012), "A comparative analysis of speech rate and perception in radio bulletins", Text & Talk 32(3), 391-411: https://doi.org/10.1515/text-2012-0019