Words per minute for video scripts: script length calculator
A one-minute video script is roughly 150 to 180 words at a clear speaking pace. Paste a script or a word count to get its read time, or pick a target length to get a word budget.
By our team. Published . 4 sources.
Script read-time calculator
Read time
1:56
300 words at 155 words a minute
How many words for a video of
About 155 words for 1 min at 155 words a minute.
A one-minute video script is about 150 to 180 words if you speak at a clear, steady pace, and closer to 150 if you leave room to pause. To time a script, divide its word count by your speaking rate in words per minute: 300 words at 150 words a minute takes 2 minutes. The calculator above does both directions, and the table below gives word budgets for common video lengths.
The rates in the presets are not guesses. Audiobook narrators average about 155 words a minute [1], radio news is usually written for 160 to 180 [2], and in a listening study, news read at 170 to 190 words a minute was remembered best while 230 was too fast to follow [3][4]. Your own rate is what matters, though, so the best number to use is one you have measured (see "How to time your own script" below).
Word counts for common video lengths
Each figure is the rate multiplied by the length, rounded down to whole words, so you can use it as a ceiling when you write.
| Length | 150 wpm | 155 wpm (narration) | 170 wpm (news) | 180 wpm (brisk) |
|---|---|---|---|---|
| 15 seconds | 37 | 38 | 42 | 45 |
| 30 seconds | 75 | 77 | 85 | 90 |
| 60 seconds | 150 | 155 | 170 | 180 |
| 90 seconds | 225 | 232 | 255 | 270 |
| 2 minutes | 300 | 310 | 340 | 360 |
| 3 minutes | 450 | 465 | 510 | 540 |
| 5 minutes | 750 | 775 | 850 | 900 |
These counts are speaking time only. If your video has a title card, a pause for a demo, or a few seconds of B-roll with no voice, subtract that time first and then look up the budget for what is left.
How speaking rate changes with the kind of video
Pace depends on how much the listener has to take in, and on whether they can also see what you are talking about.
| Kind of speech | Typical rate | Source |
|---|---|---|
| Audiobook narration | About 155 wpm (9,300 words an hour) | ACX [1] |
| Radio news, recommended | 160 to 180 wpm | Rodero 2012 [2] |
| BBC radio bulletins, measured | About 168 wpm, the only station of four inside the recommended range | Rodero 2012 [2] |
| News in a listening test | 150 felt slow, 170 to 190 felt normal and was remembered best, 210 felt fast, 230 was too fast | Rodero 2015 [3][4] |
What this means for video:
- Explainers and tutorials sit at the narration end. Viewers are learning, often following along on their own screen, so a pace near 150 to 155 gives them time.
- News-style updates, announcements and promos can run at 160 to 180, as radio news does. The script has to be tighter, because there is less time to say each thing.
- Short social videos often feel faster than they are because they are cut tightly between sentences. The words themselves usually still land in the 160 to 180 range; the speed comes from removing the gaps.
One caution about the listening study: it used Spanish radio news, and word rates differ between languages, so treat its exact numbers as a guide to the shape of the curve (too slow hurts, too fast hurts more) rather than precise English targets [4]. The BBC figure and the ACX figure are English.
Why on-camera reads run longer than you think
Most people who time a script by reading it silently, or by mumbling it at their desk, end up with a video that runs long. Four things add time on camera:
- Pauses. A word count measures speech, not the breath between sentences, the beat after a joke or the pause while you point at something. A word-count estimate is a minimum.
- Emphasis. When you perform rather than read, you stretch the words that matter. That is good delivery, and it costs seconds.
- Reading load. Reading from a prompter while keeping your face relaxed is harder than talking, and you may slow down to stay on top of it, especially in the first few takes.
- Numbers, names and symbols. "2026" counts as one word but you say two or three ("twenty twenty-six"), and "£1,250" counts as one but you say seven ("one thousand, two hundred and fifty pounds"). If your script is full of figures, count them as you would say them.
The fix is simple: time one real read before you trust any estimate, then adjust the word count, not your pace.
How to time your own script
- Pick a passage of about 150 words from your script, or a script like it.
- Read it out loud at the pace you would use on camera, standing or sitting as you will be when you film. Use a stopwatch.
- Divide the words by the seconds, then multiply by 60. For example, 150 words in 66 seconds is 150 ÷ 66 × 60, about 136 words a minute.
- Type that rate into the calculator and use it for the whole script.
- Do this again after a few videos, because your pace can change as you get used to the camera.
If the script comes out long, cut words rather than reading faster. A clear script read at your natural pace beats a crammed one read in a rush, and your viewers can hear the difference.
How teleprompter speed relates to words per minute
Many teleprompter apps set the scroll speed in their own units, such as a number from 1 to 10 or lines per second, so the same setting moves different amounts of text depending on font size and screen width. That makes it hard to plan. A prompter that sets speed in words per minute lets you use the numbers on this page directly: set it to your measured rate and the scroll will finish when your read time says it should.
There are two ways a prompter can move:
- By the clock. The text scrolls at a fixed rate. Set it a little below your measured pace, because pauses and emphasis slow you down, and tap to pause if you fall behind.
- By your voice. The app listens and moves the text as you speak, so your pace sets the speed and pauses cost nothing. This is the easier option for most people, because you never chase the text.
Cuefold, our teleprompter camera for iPhone and iPad, sets its prompter speed in words per minute, starting at 140 and adjustable in steps of 10, and shows how long the script will take to read at that speed. Its Voice Follow mode scrolls with your voice instead.
A quick worked example
You want a 45-second Instagram video and you measured your pace at 160 words a minute. Your word budget is 160 × 45 ÷ 60 = 120 words. Your opening title card takes 3 seconds with no speech, so you really have 42 seconds: 160 × 42 ÷ 60 = 112 words. Write to 110 and you will have a little room to breathe.
Common questions
- How many words is a 1 minute script?
- About 150 to 180 words. At an unhurried 150 words a minute it is 150 words; at a news-style 170 to 180 it is 170 to 180. Audiobook narrators average about 155 words a minute [1], and radio news is usually written for 160 to 180 [2]. Measure your own pace for the most accurate number.
- How many words is a 30 second script?
- About 75 words at 150 words a minute, 85 at 170 and 90 at 180. If the video opens with a few silent seconds, subtract them first.
- How long does it take to say 500 words?
- About 3 minutes 20 seconds at 150 words a minute, just under 3 minutes at 170, and about 2 minutes 47 seconds at 180. Pauses add to that.
- What is a normal speaking rate in words per minute?
- For prepared speech in English, about 150 to 180 words a minute. Audiobook narration averages about 155 [1], and radio news is usually written for 160 to 180, with BBC bulletins measured at about 168 [2].
- Is 200 words per minute too fast for a video?
- Usually, yes, for a whole script. In a listening study of radio news, 170 to 190 words a minute was remembered best, 210 felt fast and 230 was too fast to follow [3][4]. A short burst at that speed can work for energy, but cut words rather than reading the whole script that fast.
- Why is my video longer than my word count says?
- Because a word count measures speech only. Pauses, emphasis, numbers said in full and the extra care of reading from a prompter all add time. Time one real read aloud and use that rate instead of an average.
Sources
Checked on 5 November 2026.
- 1.ACX Help Center, "How long will my narrated audiobook be?" (about 9,300 words an hour): https://help.acx.com/s/article/how-long-will-my-narrated-audiobook-be
- 2.Rodero, E. (2012), "A comparative analysis of speech rate and perception in radio bulletins", Text & Talk 32(3), 391-411: https://doi.org/10.1515/text-2012-0019
- 3.Rodero, E. (2015), "Influence of Speech Rate and Information Density on Recognition: The Moderate Dynamic Mechanism", Media Psychology: https://doi.org/10.1080/15213269.2014.1002942
- 4.The Journalist's Resource, "Radio news: How the pace, density of broadcasts affect what audiences understand, remember" (summary of Rodero 2015): https://journalistsresource.org/?p=48675